- Elm-usb Interface Port Devices Driver Download For Windows 8
- Elm-usb Interface Port Devices Driver Download For Windows 7
| This article will guide you on how to install ALDL USB cable on your Windows system. It will then successfully work with OBD-I software (like award-winning TOAD) and your car. (If this step is missed, then OBD software is not going to work. So it's CRUCIAL that you follow below steps). Other Resources: Where to buy ALDL Cable: USA / Australia |
- Intel(R) ICH9M/M-E 2 port Serial ATA Storage Controller 2 - 292D Intel(R) ICH9 Family SMBus Controller - 2930 Intel(R) ICH9 Family USB Universal Host Controller - 2934.
- In Device Manager at Redmi 7A, Properties: “The drivers for this device have not installed. (Code 28) There are no compatible drivers for this device. To find a driver for this device, click Update Driver. ” After I activated the Update Driver button, I received the following responses: “Windows could not find drivers for your device”.
The procedure for installing the virtual COM port driver on a Windows® 7 (64 bit version) system is shown be- low. Start Windows® 7. Shut down all running applications.
Most ALDL cables come with a CD (drivers) and installation instructions. Refer to their instructions first.
Otherwise, proceed to Step 2.
Download ALDL Cable Drivers here.
Then unextract the file anywhere on your computer.
Once you plug-in the cable into your computer — Windows Vista, 7, 8 will likely install drivers automatically. Without you having to do anything. In which case you can immediately connect other end to the car, load up the OBD software and start scanning/tuning.
Windows XP will ask you to specify/browse location of where drivers are found. Choose the same folder where you extracted drivers in STEP 2 above. It'll then install and you're all setup!
If driver install fails, then you can retry inside Control Panel. Here's how...
- Windows Vista/7/8: Control Panel » System » Device Manager
- Windows XP: Control Panel » System » 'Hardware' tab » Device Manager
You'll then see a device similar to 'USB Serial Port' under either 'Other devices' or 'Ports (COM & LPT)'.
Right-click and choose 'Update Driver Software'. Like this:
Then select the folder in Step 2 above.
Go to Control Panel.
- Windows Vista/7/8: Control Panel » System » Device Manager
- Windows XP: Control Panel » System » 'Hardware' tab » Device Manager
Expand 'Other devices' or 'Ports (COM & LPT)'. Whichever contains 'USB Serial Port'.
Next to 'USB Serial Port' — you'll see a number. Keep note of that number. EG: COM5.
You'll have to specify that inside OBD software, so that it can recognize the cable.
All that's left now is to plug the other end of ALDL cable to your cars port.
Launch OBD1 software like TOAD — specify within the software your ALDL COM port number (as per Step 4 above), and Connect!
Elm-usb Interface Port Devices Driver Download For Windows 8
Use this ALDL tester software to verify that your ALDL cable is recognized and properly installed to Windows.
Elm-usb Interface Port Devices Driver Download For Windows 7
It'll also tell you what COM port number (as discussed in Step 4 above), your ALDL cable is using.